Commercial Roofing in Houston & Fort Bend County

Commercial roofing systems we install

Flat and low-slope commercial roofs fail differently than residential shingle roofs. Water pools instead of running off, penetrations multiply across HVAC curbs and vents, and a slow leak can damage inventory or equipment long before anyone notices. The right system depends on your building’s slope, existing membrane condition, drainage layout, and how long you need it to last. Here is what we work with:

TPO Membrane	Thermoplastic polyolefin is the most common system on flat commercial roofs in this climate. Heat-welded seams, strong UV resistance, and a white surface that reflects heat well. Works on most flat and low-slope decks and is usually the cost-effective default when the existing membrane has reached the end of its life.
Modified Bitumen	Two-ply torch-applied or cold-adhesive system that handles ponding water well. A good choice for roofs with complex drainage, high foot-traffic areas, or older buildings where the deck condition is uncertain. The granulated cap sheet gives it impact resistance that single-ply membranes do not have.
Metal Roofing	Standing-seam and R-panel systems for commercial applications. Works on buildings with enough pitch to shed water and for owners who want a long service life with minimal maintenance. R-panel is the lower-cost option for agricultural and light-industrial buildings. Standing seam is the right call when longevity and aesthetics both matter.
Roof Coatings	Silicone and elastomeric coatings applied over an existing membrane that still has structural integrity. Not a repair for a failing roof, but an effective way to extend the life of a roof that does not yet need full replacement. Substantially cheaper than a tear-off when the existing substrate qualifies.

What we inspect on a commercial roof

A flat or low-slope roof has a longer list of failure points than a residential shingle roof. Our inspection covers the full system:

• Membrane condition. Blistering, splitting, punctures, and seam separation are the most common failure modes. We document location and extent on all of them.
• Flashing at walls, curbs, and penetrations. HVAC curbs, pipe boots, skylights, and parapet walls are where flat roofs fail most often. Each one gets photographed.
• Drainage. Internal drains, scuppers, and gutters. Blocked drainage is the leading cause of accelerated membrane wear on flat roofs in Houston.
• Deck condition. Where we can access it, we check for delamination, rot, or soft spots that would affect the new system’s attachment.
• Existing insulation. On re-cover projects, insulation moisture content matters. Wet insulation under a new membrane traps heat and destroys the roof from below.

How commercial roofing quotes work

We do not quote commercial roofing over the phone. The price depends on square footage, existing membrane condition, the number and type of penetrations, whether the deck needs repair, and which system you choose. A building we can walk in two hours and a building we need a full morning on are priced differently, and no honest contractor can skip that step.

What you get after the inspection: a written scope of work with line-item pricing, photographs of every condition we found, and a clear recommendation on repair versus replacement. You keep the report whether or not you hire us.

Service area for commercial roofing

We work on commercial properties in Richmond, Rosenberg, Sugar Land, Missouri City, Stafford, Katy, Fulshear, and across Fort Bend County. We also serve the Highway 6 corridor and west Houston in Harris County. If your building is within roughly 25 miles of Richmond, call and we will tell you whether it is in range.

★★★★★

“Cannot recommend these guys enough. We had an emergency roof replacement need and they were incredibly responsive and professional from beginning to end. They were on site the next day with a quote by the afternoon. The job was completed two days later. Their price was market-competitive and they did a great job.”

Common Questions